Brainboxes ES-020 Manual descarregar pdf (Página 29)

ES Range Product Manual

Version 2.8

Page 29 of 57

5. Click the „Apply Changes‟ button and you will be taken to a page which will display a success

page. You will be redirected to the port page after the count down timer has finished.

6. The devices will now be in tunneling mode.

7. On the Local device port webpage you will see displayed the device tunneling section with

two buttons, „Disconnect‟ and „Stop Tunneling‟. By clicking the „Stop Tunneling‟ button this

will disconnect the ports on the remote and local side and put both of the devices into an idle

state. If the „Disconnect‟ button is clicked the remote side port will be disconnected and go

into the idle state, but the local side will remain in tunneling mode.

8. When the remote port is disconnected the local port webpage shows a „Connect‟ button.

When this button is pressed the remote device will be connected to the local device and

tunneling will be connected.

9. On the remote device port webpage interface, on the Serial port that is tunneling it will show

that the port is connected.

10. In Boost.LAN Manager, the symbol in the

image to the right will be displayed when a

device in is connected in tunneling mode.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 56 57

Sem comentários

Brainboxes ES-020 Manual Página 29