Brainboxes PX-246 Especificações descarregar pdf (Página 56)

Operation

6.4 START INHIBIT/RESET

NOTE:

NOTE:NOTE:

NOTE:

If a digital input configur

If a digital input configurIf a digital input configur

If a digital input configured to

ed to ed to

ed to

panel lock

panel lockpanel lock

panel lock

is active,

is active, is active,

is active, changing module modes will

changing module modes will changing module modes will

changing module modes will

not be possible. Viewing the instruments and event logs is NOT affected by panel lock.

not be possible. Viewing the instruments and event logs is NOT affected by panel lock. not be possible. Viewing the instruments and event logs is NOT affected by panel lock.

not be possible. Viewing the instruments and event logs is NOT affected by panel lock.

State Inhibit mode is activated by pressing the button.

In START INHIBIT

‘ ’

mode, the module will remove S2 from load (if necessary) and remove the

start signal given to the generator controller (if S2 is configured as a generator and it is running).

If S2 is configured as a generator and it does not stop after the cooling down time, the FAIL TO STOP

alarm is activated (subject to if the FAIL TO STOP timer si enabled and its duration). To detect the

generator (S2) is at rest the following must occur:

• S2 Frequency must be zero.

• S2 Voltage must be zero.

Any latched alarms that have been cleared will be reset when START INHIBIT

‘ ’

mode is entered.

S2 will not be placed on load (or started if configured as a generator) when in START INHIBIT

‘ ’

mode. If remote start signals are given, the input is ignored until AUTO

‘ ’

mode is entered.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 81 82

Comentários a estes Manuais

Sem comentários

Brainboxes PX-246 Especificações Página 56

Comentários a estes Manuais